*Product may vary by application
WARNING: Cancer and Reproductive harm - www.p65warnings.ca.gov
Description
In the wake of the success of our well respected Fender Eliminator Kits, Yoshimura is now offering high-end LED turn signal kits.
We have two kits, a front and a rear. Both the front and rear are two-wire kits and can be mounted on most of today's motorcycles.
Our Front kit contains:- A CE certified set of Two-Wire LED lights with a clear lens in a rubber insulated, anodized black aluminum body
- Mounting hardware
Yoshimura Diode kit may be required when using LED turn signals. (sold separately) If you have a single-bulb turn signal indicator, Diode kit is required for proper turn signal operation. Diode Kit is designed to remedy turn signal issues where the turn signal light stays illuminated and does not flash as a result of switching to LEDs.
. . . . .
This product was designed to fit on a standard equipped motorcycle, as delivered from the factory. OE and aftermarket accessories not found on a bike as delivered from the factory may not be compatible with this product.
Attention international customers: This product was designed and tested to be compatible with vehicles in the U.S. marketplace only. Compatibility, including fitment and performance, may vary by marketplace.
Instructions
Open tab
Instructions / What's Included PDFVehicle Fitment
Open tabPurchased 2 sets of signals plus the license plate mount bracket to replace the worn/cracked/weathered signals on my 2006 Speed Triple. The build quality is excellent and it's a vastly cleaner look over the OEM signals. Install was simple and straightforward and they're highly visible and bright despite their small form factor.
The signals come with a nice set of bullet connectors installed with a crimp-on terminal for the bike harness side. Unfortunately, these terminals require a special crimping tool that I did not have access to. Instead, I substituted blue knife (aka "handshake") connectors (P/N 32448) that did the trick. Just be sure to isolate them with a sleeve or heat shrink so that they don't short against each other or the frame.
For the Speed Triple, an EP35 LED flasher relay is an easy plug and play replacement for the OEM Hella relay to eliminate rapid flashing, available off the shelf at any autoparts store.
Overall an excellent upgrade over OEM.
Just installed these on my 22 Grom. It’s a little disappointing for the price of these that they don’t include a third wire for the running lights. On a bike this small, I’d like to have as much light on the front as possible to help be seen. I know it says in the description they are two wire lights, but until I got into the bikes harness, I didn’t know it was three wires. Maybe you could offer a two wire or three wire light, let customers choose what they prefer. The overall quality of these seem to be outstanding, time will tell how they hold up but I don’t think I will have any issues.
Thanks for your recommendations we will definitely keep the 3-wire crowd in mind as we expand the product line.
